Configure Fax Passthrough A: Difference between revisions

Latest revision as of 10:50, 9 September 2022

This article applies to:	Product	Version
This article applies to:	Tmedia	2.6, 2.7

To enable passthrough:

1. Select Profiles from the navigation menu.

2. Set Detection Mode to Standard.

3. Set Relay Mode to Passthrough.

4. Check the Switch to FAX relay upon CNG tone option.

5. Set Detection type to "Silence Suppression off"

6. Verify the the Codec is the same as the remote end.

@@ Line 1: / Line 1: @@
-To enable passthrough, follow these steps:
+{{DISPLAYTITLE:Configure Fax Passthrough}}
-<pre>
-. Make sure "Enable Fax/Modem Relay" is enabled.
+{| class="wikitable"
-. Make sure "Detection Mode" is Standard.
+|-
-. Make sure "Relay Mode" is Passthrough.
+|rowspan="2"|This article applies to:
-. Make sure "Enable switching to FAX relay upon CNG tone" is checked.
+|'''Product'''
-. Make sure "Detection type" is "Silence Suppression off"
+|'''Version'''
-. Make sure the Codec is the same as the remote end.
+|-
-</pre>
+|Tmedia
+|2.6, 2.7
+|}
+'''To enable passthrough:'''
+. Select '''Profiles''' from the navigation menu.
+[[Image:Profiles_0.png]]
+. Set '''Detection Mode''' to Standard.
+. Set '''Relay Mode''' to Passthrough.
+. Check the '''Switch to FAX relay upon CNG tone''' option.
+. Set '''Detection type''' to "Silence Suppression off"
+. Verify the the Codec is the same as the remote end.
+[[Image:Profile_passthru_silence_v26.png]]