Toolpack:Adding M2PA Links B: Difference between revisions
m (Updated IP header TOS link) |
|||
| (4 intermediate revisions by one other user not shown) | |||
| Line 6: | Line 6: | ||
1- Click ''' | 1- Click '''M2PA''' in the navigation panel: | ||
[[Image:CreateM2pa_0.png]] | [[Image:CreateM2pa_0.png]] | ||
2- | 2- Select an M2PA SAP: | ||
[[Image:SelectM2paLink_0.png]] | [[Image:SelectM2paLink_0.png]] | ||
| Line 29: | Line 29: | ||
** [[TTC]] | ** [[TTC]] | ||
* Set other features, as needed: | * Set other features, as needed: | ||
** '''Destination port''' (same value as the one configured on the destination side) | |||
** Number of '''SCTP Streams''' | ** Number of '''SCTP Streams''' | ||
* Click '''Create''' | * Click '''Create''' | ||
| Line 54: | Line 53: | ||
* [[Parameter: Protocol Type|Protocol Type]] | * [[Parameter: Protocol Type|Protocol Type]] | ||
* [[Parameter: Number of SCTP Streams|Number of SCTP Streams]] | * [[Parameter: Number of SCTP Streams|Number of SCTP Streams]] | ||
* [[Parameter: | * [[Parameter:_Packet_Network:_Type_of_Service|IP Header TOS]] | ||
* [[Parameter: Destination Port|Destination Port]] | * [[Parameter: Destination Port|Destination Port]] | ||
Latest revision as of 11:15, 31 October 2016
Applies to version(s): v2.8
After you create an M2PA service access point (SAP), you must create a new M2PA link. This is done from the M2PA SAP configuration window. To create an M2PA link:
1- Click M2PA in the navigation panel:
2- Select an M2PA SAP:
3- Click Create new M2pa link in the M2PA SAP configuration window:
4- Configure the new link:
- Enter a name for the link
- Select a protocol type:
- Set other features, as needed:
- Destination port (same value as the one configured on the destination side)
- Number of SCTP Streams
- Click Create
5- Enter a destination address in the appropriate box in the information panel:
- Click the "<<" button to add the destination address to the address list
6- Verify that the address has been added to the list, and that the "(your address) was successfully added" message appears (ex.: here the address is 190.0.0.0)
