Actions

Toolpack:Creating the M2PA Configuration c: Difference between revisions

(New 2.8 article)
 
 
(4 intermediate revisions by the same user not shown)
Line 1: Line 1:
=== '''''Applies to version(s): v2.8.''''' ===
=== '''''Applies to version(s): v2.8.''''' ===
{{DISPLAYTITLE:Creating the M2PA Configuration}}
{{DISPLAYTITLE:Creating the M2PA Configuration}}
Stream Control Transmission Protocol (SCTP), a Transport Layer protocol, ensures reliable, in-sequence transport of messages.
 
   
   
To edit your system's SCTP configuration:
To create an M2PA configuration:


1- Select '''SCTP''' from the navigation panel
1- Select '''M2PA''' from the navigation panel


[[Image:CreateM2pa_0.png]]
[[Image:CreateM2pa_0.png]]


2- Configure the SCTP service
 
2- Configure the M2PA service


* Make sure the box labelled '''Enabled''' is '''checked'''
* Make sure the box labelled '''Enabled''' is '''checked'''
* Enter a '''name''' for the SCTP service
* Enter a '''name''' for the M2PA service
* Select an appropriate '''service type''':
** [[RAW IP|RAW_IP]]
** [[UDP IP|UDP]]
* Click '''Create'''
* Click '''Create'''


[[Image:CreateM2pa_1.png]]
[[Image:CreateM2pa_1.png]]


3- Verify that the '''"Sctp Cfg was successfully created"''' message appears
 
3- Verify that the '''"M2pa Cfg was successfully created"''' message appears


[[Image:CreateM2pa_2.png]]
[[Image:CreateM2pa_2.png]]


==List of Parameter==
==List of Parameter==


* [[Parameter: Name|Name]]
* [[Parameter: Name|Name]]
* [[Parameter: Service Type|Service Type]]

Latest revision as of 10:46, 18 September 2014

Applies to version(s): v2.8.

To create an M2PA configuration:

1- Select M2PA from the navigation panel


2- Configure the M2PA service

  • Make sure the box labelled Enabled is checked
  • Enter a name for the M2PA service
  • Click Create


3- Verify that the "M2pa Cfg was successfully created" message appears

List of Parameter

Retrieved from "https://docs.telcobridges.com/w/index.php?title=Toolpack:Creating_the_M2PA_Configuration_c&oldid=16354"