Toolpack:Creating an MTP3 Network B: Difference between revisions
mNo edit summary |
m (→Applies to version(s): v2.8: typo) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 6: | Line 6: | ||
To create an MTP3 network: | To create an MTP3 network: | ||
1- Click '''MTP3''' in the | 1- Click '''MTP3''' in the navigation pane. | ||
[[Image:Mtp3_0_A.png]] | [[Image:Mtp3_0_A.png]] | ||
| Line 26: | Line 26: | ||
[[Image: | [[Image:CreateMtp3Network_1.png]] | ||
| Line 32: | Line 32: | ||
[[Image: | [[Image:CreateMtp3Network_2.png]] | ||
==List of Parameters== | ==List of Parameters== | ||
Latest revision as of 09:13, 16 September 2014
Applies to version(s): v2.8
After the MTP3 configuration is created, you must also create a new MTP3 network. An MTP3 network is created to define its point codes, link sets and routes. This can be done from the MTP3 configuration information panel
To create an MTP3 network:
1- Click MTP3 in the navigation pane.
2- Click Create New MTP3 Network in the MTP3 configuration information panel
3- Configure the settings for the new network:
- Enter a name for the network
- Select a sub service field
- Select a link type
- Select the SS7 DPC length
- Click Create
4- Verify that the Mtp3Network was successfully created message appears
