Cbilodeau: return page content to redirect page

2013-02-26T14:08:43Z

return page content to redirect page

← Older revision		Revision as of 10:08, 26 February 2013
Line 1:		Line 1:
	~~#REDIRECT~~ [[~~Configuring~~ IP Interfaces]]		The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:

			*IP Address
			*Netmask
			*Gateway

			<br>

			== To configure a VoIP0 or VoIP1 port ==

			1. Select '''IP Interfaces''' from the navigation panel:

			[[Image:Toolpack v2.5 Navigation Panel IP Interfaces.png]]

			<br> 2. Click '''Edit''' from the IP Interfaces Information panel:

			[[Image:Toolpack v2.5 Edit IP Interface.png]]

			<br> 3. Configure the IP port:

			*Indicate whether or not to use '''DHCP''' on this port
			*Enter an '''IP address'''
			*Enter a '''Netmask'''
			*Enter a '''gateway address'''
			*Click '''Save'''

			'''Note:''' The IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets. <br>

			[[Image:Toolpack v2.5 Editing IP Interface.png]]

			<br>

			4. The changes are displayed in the IP interfaces information panel:

			[[Image:Toolpack v2.5 IP Interface Edited.png]]

			<br> '''IMPORTANT!''' The system will display the following notice, describing steps to apply your new configuration:

			[[Image:Toolpack v2.5 IP Interface Alert.png]]

			<br>

			5. Activate the configuration

			Systems -> Edit -> Activate



			6. Reboot the adapter (will drop active calls)

			Status -> Adapters -> Click on the adapter Serial Number -> Reboot adapter

			It will take about 1.5 minutes to restart the unit.

			== List of Parameters ==

			*[[Parameter: Use DHCP\|Use DHCP]]
			*[[Parameter: IP Address\|IP Address]]
			*[[Parameter: Netmask\|Netmask]]
			*[[Parameter: Gateway\|Gateway]]

Allyntree: moved Toolpack v2.5:Configuring IP Interfaces to Configuring IP Interfaces: New naming convention

2012-07-09T18:13:54Z

New page

#REDIRECT [[Configuring IP Interfaces]]