Toolpack:Modifying ISUP Stack for SPIROU A - Revision history

Luc Morissette: Changed numbering scheme

2014-01-07T13:02:42Z

Changed numbering scheme

← Older revision		Revision as of 09:02, 7 January 2014
Line 13:		Line 13:
	2- Click on the '''Edit''' button for the ISUP stack you want to configure		2- Click on the '''Edit''' button for the ISUP stack you want to configure

	2- Expand the '''Advanced Parameters''' section and check the following parameters		3- Expand the '''Advanced Parameters''' section and check the following parameters
	* '''No confusion''' must be chosen		* '''No confusion''' must be chosen

	3- Click the '''Save''' button		4- Click the '''Save''' button

	4- Verify that the '''"IsupStack was successfully updated"''' message is displayed		5- Verify that the '''"IsupStack was successfully updated"''' message is displayed

	==List of Parameters==		==List of Parameters==

	* [[Parameter: Isup Stack Options\|Isup Stack Options]]		* [[Parameter: Isup Stack Options\|Isup Stack Options]]

Manon Bélanger: Added List of Parameters

2012-12-14T20:05:53Z

Added List of Parameters

← Older revision		Revision as of 16:05, 14 December 2012
Line 19:		Line 19:

	4- Verify that the '''"IsupStack was successfully updated"''' message is displayed		4- Verify that the '''"IsupStack was successfully updated"''' message is displayed

			==List of Parameters==

			* [[Parameter: Isup Stack Options\|Isup Stack Options]]

Manon Bélanger: First version of the page to configure ISUP stack for SPIROU

2012-12-12T22:38:28Z

First version of the page to configure ISUP stack for SPIROU

New page

=== '''''Applies to version(s): v2.6, v2.7.''''' ===
{{DISPLAYTITLE:Modifying ISUP Stack for SPIROU}}

This section assumes:
* '''SS7 ISUP is already configured'''

Note that if you want to eventually validate SPIROU configuration, you will need to repeat these steps for all the ISUP stacks in your current configuration..

1- Select '''SS7-->ISUP''' from the navigation panel

2- Click on the '''Edit''' button for the ISUP stack you want to configure

2- Expand the '''Advanced Parameters''' section and check the following parameters
* '''No confusion''' must be chosen

3- Click the '''Save''' button

4- Verify that the '''"IsupStack was successfully updated"''' message is displayed