Allyntree: Changed response message image

2019-08-05T18:19:55Z

Changed response message image

← Older revision		Revision as of 14:19, 5 August 2019
Line 19:		Line 19:
	[[Image:Mtp3_1_A.png]]		[[Image:Mtp3_1_A.png]]

	3- Verify that the '''"~~Mtp3Cfg~~ was successfully created"''' message appears		3- Verify that the '''"Mtp3 Stack was successfully created"''' message appears

	~~[[Image:Mtp3_2_A.png]]~~

			[[Image:Mtp3_2_A_1.png]]

	==List of Parameters==		==List of Parameters==

Allyntree: Created page with "=== '''''Applies to version(s): v3.0''' === {{DISPLAYTITLE:Creating an MTP3 Configuration}} Once you have set up the MTP2 layer of your SS7 system, you must create an MTP3 con..."

2019-08-05T18:14:25Z

Created page with "=== '''''Applies to version(s): v3.0''' === {{DISPLAYTITLE:Creating an MTP3 Configuration}} Once you have set up the MTP2 layer of your SS7 system, you must create an MTP3 con..."

New page

=== '''''Applies to version(s): v3.0''' ===
{{DISPLAYTITLE:Creating an MTP3 Configuration}}
Once you have set up the MTP2 layer of your SS7 system, you must create an MTP3 configuration.
[[MTP3_Layer|MTP3]] provides message routing between signaling points in an SS7 network.

To create an MTP3 configuration:

1- Select '''MTP3''' from the navigation panel

[[Image:Mtp3_0_A.png]]

2- Configure the new MTP3 service:

* Enter a '''name''' for the MTP3 configuration
* Make sure the '''Enabled''' and '''SSf Validation''' boxes are checked
* Select '''SP''' as the '''signaling point type'''
* Click '''Create'''

[[Image:Mtp3_1_A.png]]

3- Verify that the '''"Mtp3Cfg was successfully created"''' message appears

[[Image:Mtp3_2_A.png]]

==List of Parameters==
* [[Parameter: Name|Name]]
* [[Parameter: Enabled|Enabled]]
* [[Parameter: Signaling Point Type|Signaling Point Type]]

'''Timers'''
* [[Parameter: MTP3 T15 Timer|T15 Timer]]
* [[Parameter: MTP3 T16 Timer|T16 Timer]]
* [[Parameter: MTP3 T18 Timer|T18 Timer]]
* [[Parameter: MTP3 T19 Timer|T19 Timer]]
* [[Parameter: MTP3 T21 Timer|T21 Timer]]
* [[Parameter: MTP3 T26 Timer|T26 Timer]]

'''Advanced Parameters'''
* [[Parameter: MTP3 Ssf Validation|Ssf Validation]]
* [[Parameter: MTP3 Transfer Restricted required|Transfer Restricted required]]

Toolpack:M3UA Use Case A:Configure MTP3 A - Revision history

Allyntree: Changed response message image

Allyntree: Created page with "=== '''''Applies to version(s): v3.0''' === {{DISPLAYTITLE:Creating an MTP3 Configuration}} Once you have set up the MTP2 layer of your SS7 system, you must create an MTP3 con..."