Allyntree: Created page with "=== '''''Applies to version(s): v2.7''''' === {{DISPLAYTITLE:Creating an MTP3 Configuration}} Now that you have set up the MTP2 layer of your SS7 system, you must create an MT..."

2013-07-15T14:11:17Z

Created page with "=== '''''Applies to version(s): v2.7''''' === {{DISPLAYTITLE:Creating an MTP3 Configuration}} Now that you have set up the MTP2 layer of your SS7 system, you must create an MT..."

New page

=== '''''Applies to version(s): v2.7''''' ===
{{DISPLAYTITLE:Creating an MTP3 Configuration}}
Now that you have set up the MTP2 layer of your SS7 system, you must create an MTP3 configuration.
[[MTP3_Layer|MTP3]] provides message routing between signaling points in an SS7 network.

To create an MTP3 configuration:

1- Select '''MTP3''' from the navigation panel

[[Image:Mtp3_0.png]]

2- Configure the new MTP3 service:

* Enter a '''name''' for the MTP3 configuration
* Make sure the '''Enabled''' and '''SSf Validation''' boxes are checked
* Select '''SP''' as the '''signaling point type'''
* Select a '''restart procedure'''
* Click '''Create'''

[[Image:Toolpack_v2.6_Creating_MTP3.png]]

3- Verify that the '''"Mtp3Cfg was successfully created"''' message appears

[[Image:Toolpack_v2.5_MTP3_Created.png]]

==List of Parameters==

* [[Parameter: Name|Name]]
* [[Parameter: Enabled|Enabled]]
* [[Parameter: SSf Validation|SSf Validation]]
* [[Parameter: Signaling Point Type|Signaling Point Type]]
* [[Parameter: MTP3 T15 Timer|T15 Timer]]
* [[Parameter: MTP3 T16 Timer|T16 Timer]]
* [[Parameter: MTP3 T18 Timer|T18 Timer]]
* [[Parameter: MTP3 T19 Timer|T19 Timer]]
* [[Parameter: MTP3 T21 Timer|T21 Timer]]
* [[Parameter: MTP3 T26 Timer|T26 Timer]]

Advanced Parameters
* [[Parameter: MTP3 Ssf Validation|Ssf Validation]]
* [[Parameter: Restart Procedure|Restart Procedure]]
* [[Parameter: MTP3 Transfer Restricted required|Transfer Restricted required]]

Toolpack:Creating an MTP3 Configuration C - Revision history

Allyntree: Created page with "=== '''''Applies to version(s): v2.7''''' === {{DISPLAYTITLE:Creating an MTP3 Configuration}} Now that you have set up the MTP2 layer of your SS7 system, you must create an MT..."