Toolpack:Creating an M2UA SAP B - Revision history

Allyntree at 14:09, 1 October 2014

2014-10-01T14:09:08Z

← Older revision		Revision as of 10:09, 1 October 2014
Line 31:		Line 31:
	5- Associate an IP interface with the new SAP:		5- Associate an IP interface with the new SAP:

	* Select an '''IP interface''' from the list of '''Available''' IP ~~interfaced~~		* Select an '''IP interface''' from the list of '''Available''' IP interfaces
	* Click '''"<<"''' to ~~aAssociate~~ the interface with the SAP		* Click '''"<<"''' to associate the interface with the SAP

	[[Image:Create_M2UA_SAP_3.png]]		[[Image:Create_M2UA_SAP_3.png]]

Allyntree at 14:08, 1 October 2014

2014-10-01T14:08:35Z

← Older revision		Revision as of 10:08, 1 October 2014
Line 31:		Line 31:
	5- Associate an IP interface with the new SAP:		5- Associate an IP interface with the new SAP:

	* Select an '''IP interface''' from the '''~~Edit IP Interfaces~~''' ~~list~~		* Select an '''IP interface''' from the list of '''Available''' IP interfaced
	* ~~Associate the interface with the SAP, using the~~ '''"<<"''' ~~button~~		* Click '''"<<"''' to aAssociate the interface with the SAP

	[[Image:Create_M2UA_SAP_3.png]]		[[Image:Create_M2UA_SAP_3.png]]

Allyntree: New 2.8 article

2014-10-01T14:02:34Z

New 2.8 article

New page

=== '''''Applies to version(s): v2.8''''' ===
{{DISPLAYTITLE:Creating an M2UA SAP}}
After you create an M2UA configuration, you must create a new M2UA service access point (SAP) for your system. The SAP is an identifying label for endpoints in your network.

To create an M2UA SAP:

1- Click '''M2UA''' in the navigation panel

[[Image:Create_M2ua_0.png]]

2- Click '''Create New M2ua Sap''' in the M2UA configuration window

[[Image:Create_M2UA_SAP_0.png]]

3- Configure the new M2UA SAP:

* Enter a '''name''' for the new SAP
* Enter a number for the '''SCTP source port'''
* Click '''Create'''

[[Image:Create_M2UA_SAP_1.png]]

4- Verify that the '''"M2ua Sap was successfully created"''' message appears

[[Image:Create_M2UA_SAP_2.png]]

5- Associate an IP interface with the new SAP:

* Select an '''IP interface''' from the '''Edit IP Interfaces''' list
* Associate the interface with the SAP, using the '''"<<"''' button

[[Image:Create_M2UA_SAP_3.png]]

==List of Parameters==

* [[Parameter: Name|Name]]
* [[Parameter: SCTP Source Port|SCTP Source Port]]