Use Cases:TMG Performing M2UA Signaling Relay: Difference between revisions
mNo edit summary |
(Added link to new page: M2UA Satellite) |
||
Line 31: | Line 31: | ||
== References == | == References == | ||
*[[Toolpack:Protocol_Stack_Settings_B#M2UA.3C-.3EMTP2_Relay|Configuring MTP2 to M2UA relay]] | *[[Toolpack:Protocol_Stack_Settings_B#M2UA.3C-.3EMTP2_Relay|Configuring MTP2 to M2UA relay]] | ||
*[[M2UA_Satellite|M2UA Satellite Setings]] | |||
[[Category:Revise on Major]] | [[Category:Revise on Major]] |
Latest revision as of 14:09, 26 September 2022
Applies to version(s): v2.9 and above
In this scenario, all messages from TDM network are relayed to the IP network via Sigtran: M2UA. This can be used on a satellite link.
Note: This implementation, although based on standards, is proprietary.
Normally, one end is the SG and the other is the MGC.
So in this use case, one of the TMGs simulates the MGC. All of this is transparent to the TDM devices interconnected over IP.
Configure TMG: M2UA Relay | Configure TMG: M2UA SG |
---|---|
|
|