Use Cases:Configuring Tmedia Gateways for M3UA SGSG Passthrough: Difference between revisions
No edit summary |
No edit summary |
||
| Line 33: | Line 33: | ||
***origination point code (OPC): PC_B1 | ***origination point code (OPC): PC_B1 | ||
***destination point code (DPC): PC_A1 | ***destination point code (DPC): PC_A1 | ||
***Mask: PC_Mask (0.0.0) | |||
*** There is no need to define other PC (PC_A2, PC_A3, PC_B2, etc) | *** There is no need to define other PC (PC_A2, PC_A3, PC_B2, etc) | ||
*[[Toolpack:M3UA_Use_Case_A:Creating_an_MTP3_Linkset A|Configure an MTP3 Linkset]] | *[[Toolpack:M3UA_Use_Case_A:Creating_an_MTP3_Linkset A|Configure an MTP3 Linkset]] | ||
| Line 64: | Line 65: | ||
*[[Toolpack:M3UA_Use_Case_A:Creating an M3UA Route (IPSP) C|Create an M3UA Route]] | *[[Toolpack:M3UA_Use_Case_A:Creating an M3UA Route (IPSP) C|Create an M3UA Route]] | ||
** In this use case, two M3UA routes are needed: | ** In this use case, two M3UA routes are needed: | ||
***Route towards SGP: Psrv, | ***Route towards SGP: Psrv, PC_Mask (0.0.0), M3UA peer server configured above | ||
***Route towards Customer switch: MTP3, PC:0.0.0 mask, M3UA Userpart | ***Route towards Customer switch: MTP3, PC:0.0.0 mask, M3UA Userpart | ||
|} | |} | ||
Revision as of 16:28, 14 July 2021
Applies to version(s): v3.0 and above
|
|
This configuration allows you to pass transparently all packets destined to the service provider network represented by a Signaling gateway (SGP).
Note that the Point code is shared between the SGSG and the SGP device
| Configure MTP2 | Configure MTP3 | Configure IP Interface | Configure M3UA |
|---|---|---|---|
|
|
|
|