Actions

M2UA Status

Revision as of 04:32, 4 January 2021 by William Wong (talk | contribs) (→‎Status menu)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Applies to version(s): v2.8.


This article illustrates how to view M2UA status and to set a periodic refresh of the M2UA protocol stack. This is done from the Status menu and the Navigation panel.

Status menu

1- Click Status in the navigation panel.

Status 0.png


2- Click the SIGTRAN M2ua tab.

TabM2UA 0.png

  • Note that SCTP is used as the Transport Layer for this protocol, if any firewall is sitting between Telcobridges device and Sigtran network, this firewall needs to be set to allow SCTP traffic to pass through, and enabling the basic connectivity for sigtran link to be up


The status of the M2UA protocol stack is displayed.

StatusM2UA 0.png

Navigation Panel

1- Click M2UA from the navigation panel.

StatusM2UA 1.png

2- Click the Status tab.

StatusM2UA 2.png

3- To configure a periodic refresh of the M2UA status, select a value from Refresh Every.

  • To view the SAP status select a SAP link.

StatusM2UA 3.png

4- The SAP status is displayed

  • To view the Clusters status, click the Clusters tab.

StatusM2UA 4.png

5- Select an M2UA Cluster to view the status of its links and peers.

StatusM2UA 5.png

6- To view the status of the peers, select the Peers tab.

StatusM2UA 6.png

The status of the peers is displayed.

StatusM2UA 7.png