Actions

Setting the Role to a Primary Unit in a 1+1 System

Revision as of 17:17, 4 February 2015 by Allyntree (talk | contribs)

Applies to version v2.8

The first time that you connect to a gateway, the web portal will appear and you will be asked to select how you would like to configure its role, which can be either standalone, primary, or secondary. Once the configuration settings are applied, the gateway will start up and display the web portal configuration management tool.

To configure the host role of the gateway as the primary unit in a 1+1 system, do the following:


1- When the setup wizard is displayed, click Continue

HostRolePrimary 0 A.png


2- Select As part of a 1+1 redundant system and click Continue.

HostRolePrimary 1 A.png


3- Select The primary unit and click Continue.

HostRolePrimary 2 A.png


4- When you are asked if the unit should get configuration and packages from an existing secondary unit, select No and click Continue.

HostRolePrimary 3 A.png


5- This step is optional, however if you require you may modify the VLAN IDS to use for the control network.

  • Once you are done, click Continue.

HostRolePrimary 4 A.png


5a- This step is optional and only occurs if you clicked change internal subnets in the previous step.

  • Enter the subnet address and subnet mask for each VLAN ID and click Continue.

HostRolePrimary 5 A.png


6- Once you are satisfied with your settings, click Confirm.

HostRolePrimary 6 A.png


Allow for the host role changes to take effect.

HostRolePrimary 7 A.png


7- The Web Portal Log On page is displayed.

  • Enter the user name and password.

HostRolePrimary 8 A.png