Actions

Toolpack:Host 1Plus1 Primary A: Difference between revisions

mNo edit summary
mNo edit summary
(2 intermediate revisions by the same user not shown)
Line 1: Line 1:
=== '''''Applies to version(s) v2.8, v2.9, v2.10''''' ===
{{DISPLAYTITLE:Setting the Role to a Primary Unit in a 1+1 System}}
{{DISPLAYTITLE:Setting the Role to a Primary Unit in a 1+1 System}}
 
{| class="wikitable"
|-
|rowspan="2"|This article applies to:
|'''Product'''
|'''Version'''
|-
|Tmedia
|2.8, 2.9, 2.10, 3.0, 3.2
|}
The first time that you connect to a gateway, the web portal setup wizard will be displayed and you will be asked to select how you would like to configure the role of the gateway. Your choices are standalone, primary, or secondary. Once the role configuration settings are applied, the gateway will start up and display the web portal configuration management tool.  
The first time that you connect to a gateway, the web portal setup wizard will be displayed and you will be asked to select how you would like to configure the role of the gateway. Your choices are standalone, primary, or secondary. Once the role configuration settings are applied, the gateway will start up and display the web portal configuration management tool.  



Revision as of 10:05, 11 November 2020

This article applies to: Product Version
Tmedia 2.8, 2.9, 2.10, 3.0, 3.2

The first time that you connect to a gateway, the web portal setup wizard will be displayed and you will be asked to select how you would like to configure the role of the gateway. Your choices are standalone, primary, or secondary. Once the role configuration settings are applied, the gateway will start up and display the web portal configuration management tool.

To configure the host role of the gateway as the primary unit in a 1+1 system, do the following:


1- When the setup wizard is displayed, click Continue

HostRolePrimary 0 A.png


2- Select As part of a 1+1 redundant system and click Continue.

HostRolePrimary 1 A.png


3- Select The primary unit and click Continue.

HostRolePrimary 2 A.png


4- When you are asked if the unit should get configuration and packages from an existing secondary unit, select No and click Continue.

HostRolePrimary 3 A.png


5- If you need to change the default subnet address or subnet mask, click change internal subnets and proceed to step 5a, otherwise click Continue and go to step 6.

HostRolePrimary 4 A.png


5a- Enter the subnet address and subnet mask for each VLAN ID and click Continue.

HostRolePrimary 5 A.png


6- Once you are satisfied with your settings, click Confirm.

HostRolePrimary 6 A.png


Allow for the host role changes to take effect.

HostRolePrimary 7 A.png


7- The Web Portal Log On page is displayed.

  • Enter the user name and password.

HostRolePrimary 8 A.png