View source for Toolpack:Enabling strict SPIROU validation A

=== '''''Applies to version(s): v2.6, v2.7.''''' ===
{{DISPLAYTITLE:Enabling strict SPIROU validation}}

This section assumes that all the following steps were done :
*[[Toolpack:Modifying_Profile_for_SPIROU A|Modifying Profile for SPIROU]]
*[[Toolpack:Modifying_Gateway_Configurations_for_SPIROU A|Modifying Gateway Configurations for SPIROU]]
*[[Toolpack:Modifying_ISUP_Stack_for_SPIROU A|Modifying ISUP Stack for SPIROU]]
*[[Toolpack:Modifying_ISUP_Userpart_for_SPIROU A|Modifying ISUP Userpart for SPIROU]]


During the step [[Toolpack:Modifying_ISUP_Userpart_for_SPIROU A|Modifying ISUP Userpart for SPIROU]], a checkbox appears when SPIROU Protocol Variant is selected. 

This is a global parameter, so enabling/disabling this option will enable/disable strict SPIROU validation for all ISUP Userparts.


1- Check '''Strict SPIROU validation''' checkbox

2- Click the '''Save''' button

3- Verify that the '''"IsupUserpart was successfully updated"''' message is displayed. If not, fix any error that is reported. 
*Note : validation is done for all Profiles and all ISUP stacks in the current configuration. 


When '''Strict SPIROU validation''' is checked, the web portal validates the configuration and will not allow to save any configuration that is not compliant with SPIROU.

When passing SPIROU certification, it is highly recommended to use this option.