Actions

Creating the M2PA Configuration

Revision as of 18:43, 9 July 2012 by Allyntree (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Applies to version(s): v2.5, v2.6.

For the configuration of your SIGTRAN M2PA system, you will first need to create a new M2PA configuration. In this system, the SS7 MTP2 layer is replaced by the SIGTRAN M2PA layer which extends MTP2 signaling functionality into the IP network.

Note: M2PA replaces the MTP2 layer entirely; however, it still requires the MTP3 layer.

To create an M2PA configuration:


1- Click M2PA in the navigation panel

Toolpack v2.5 Navigation Panel M2PA.png

2- Configure the new M2PA service

  • Verify that the Enabled box is checked
  • Enter a name for the M2PA configuration
  • Click Create

Toolpack v2.5 Creating M2PA.png

3- Verify that the "M2pa Cfg was successfully created" message appears

Toolpack v2.5 M2PA Created.png


List of Parameters