Toolpack:Creating the M2PA Configuration A: Difference between revisions

Latest revision as of 14:43, 9 July 2012

Applies to version(s): v2.5, v2.6.

For the configuration of your SIGTRAN M2PA system, you will first need to create a new M2PA configuration. In this system, the SS7 MTP2 layer is replaced by the SIGTRAN M2PA layer which extends MTP2 signaling functionality into the IP network.

Note: M2PA replaces the MTP2 layer entirely; however, it still requires the MTP3 layer.

To create an M2PA configuration:

1- Click M2PA in the navigation panel

2- Configure the new M2PA service

Verify that the Enabled box is checked
Enter a name for the M2PA configuration
Click Create

3- Verify that the "M2pa Cfg was successfully created" message appears

List of Parameters

Enabled
Name

@@ Line 1: / Line 1: @@
+=== '''''Applies to version(s): v2.5, v2.6.''''' ===
+{{DISPLAYTITLE:Creating the M2PA Configuration}}
+For the configuration of your [[SIGTRAN]] [[M2PA]] system, you will first need to create a new M2PA configuration.
+In this system, the SS7 MTP2 layer is replaced by the SIGTRAN M2PA layer which extends MTP2 signaling functionality into the IP network.
 '''Note:''' [[M2PA]] replaces the MTP2 layer entirely; however, it still requires the MTP3 layer.
 To create an M2PA configuration:
 - Click '''M2PA''' in the navigation panel
@@ Line 11: / Line 17: @@
 * Verify that the '''Enabled''' box is '''checked'''
 * Enter a '''name''' for the M2PA configuration
-* Change the '''Timers''' setting, if necessary
 * Click '''Create'''
 [[Image:Toolpack_v2.5_Creating_M2PA.png]]
-- Verify that the '''M2pa Cfg was successfully created''' message appears
+- Verify that the '''"M2pa Cfg was successfully created"''' message appears
 [[Image:Toolpack_v2.5_M2PA_Created.png]]
+==List of Parameters==
+* [[Parameter: Enabled|Enabled]]
+* [[Parameter: Name|Name]]