Actions

Toolpack:Creating the M2PA Configuration A: Difference between revisions

No edit summary
No edit summary
Line 1: Line 1:
=== '''''Applies to version(s): v2.5, v2.6.''''' ===
{{DISPLAYTITLE:Toolpack: Navigating the Web Portal}}
For the configuration of your [[SIGTRAN]] [[M2PA]] system, you will first need to create a new M2PA configuration.
For the configuration of your [[SIGTRAN]] [[M2PA]] system, you will first need to create a new M2PA configuration.
In this system, the SS7 MTP2 layer is replaced by the SIGTRAN M2PA layer which extends MTP2 signaling functionality into the IP network.
In this system, the SS7 MTP2 layer is replaced by the SIGTRAN M2PA layer which extends MTP2 signaling functionality into the IP network.

Revision as of 18:07, 7 June 2012

Applies to version(s): v2.5, v2.6.

For the configuration of your SIGTRAN M2PA system, you will first need to create a new M2PA configuration. In this system, the SS7 MTP2 layer is replaced by the SIGTRAN M2PA layer which extends MTP2 signaling functionality into the IP network.

Note: M2PA replaces the MTP2 layer entirely; however, it still requires the MTP3 layer.

To create an M2PA configuration:


1- Click M2PA in the navigation panel

Toolpack v2.5 Navigation Panel M2PA.png

2- Configure the new M2PA service

  • Verify that the Enabled box is checked
  • Enter a name for the M2PA configuration
  • Click Create

Toolpack v2.5 Creating M2PA.png

3- Verify that the "M2pa Cfg was successfully created" message appears

Toolpack v2.5 M2PA Created.png


List of Parameters