Toolpack:Creating an SCCP Route A: Difference between revisions
No edit summary |
No edit summary |
||
Line 38: | Line 38: | ||
* [[Parameter: SLS Mask|SLS Mask]] (For ANSI and TELCORDIA variants only) | * [[Parameter: SLS Mask|SLS Mask]] (For ANSI and TELCORDIA variants only) | ||
* [[Parameter: Destination Point Code|Destination Point Code]] | * [[Parameter: Destination Point Code|Destination Point Code]] | ||
==Navigation== | |||
{| class="wikitable" | |||
|- | |||
! Previous !! Next | |||
|- | |||
| [[Toolpack_v2.5:Creating_an_SCCP_LSAP|Create an SCCP LSAP]] || [[Toolpack_v2.5:Creating_an_SCCP_SSN|Create an SCCP SSN]] | |||
|} |
Revision as of 12:31, 11 May 2012
Now that you have created an SCCP LSAP, you must create a new SCCP route for your system. This step in the Web Portal configuration exists to create a route to a specific destination point code (DPC).
To Create an SCCP Route:
1- Click Create new Sccp Route in the SCCP LSAP configuration window
2- Configure the new SCCP Route:
- Choose a Name for the new route
- Select a Protocol Variant
- Select a Replication Mode (ANSI96 and TELCORDIA variants)
- Select an SLS Mask (ANSI and TELCORDIA protocol variants)
- Select a Destination Point Code for this route
- Click Create
3- Verify that the "SccpRoute was successfully created" message appears
4- Configure SCCP Route Backup Point Code
- Assign Backup Point Codes to use in case this route's DPC is not available.
- Note: For each selected point codes, a valid SCCP route must be exist.
List of Parameters
- Name
- Protocol Variant
- Replication Mode
- SLS Mask (For ANSI and TELCORDIA variants only)
- Destination Point Code
Previous | Next |
---|---|
Create an SCCP LSAP | Create an SCCP SSN |