Actions

Toolpack:Creating an SCCP Route A: Difference between revisions

No edit summary
No edit summary
Line 13: Line 13:
* Choose a [[Parameter: Name|Name]] for the new route
* Choose a [[Parameter: Name|Name]] for the new route
* Select a [[Parameter: Protocol Type|Protocol Variant]]
* Select a [[Parameter: Protocol Type|Protocol Variant]]
* Select a [[Parameter: Replication Mode|Replication Mode]]
* Select a [[Parameter: Replication Mode|Replication Mode]] (ANSI96 and TELCORDIA variants)
* Select an [[Parameter: SLS Mask|SLS Mask]] (this is only for ANSI and TELCORDIA protocol variants)
* Select an [[Parameter: SLS Mask|SLS Mask]] (ANSI and TELCORDIA protocol variants)
* Select a [[Parameter: Destination Point Code|Destination Point Code]] (DPC) of the node where the route is terminating
* Select a [[Parameter: Destination Point Code|Destination Point Code]] (DPC) of the node where the route is terminating
* Click '''Create'''
* Click '''Create'''

Revision as of 10:00, 11 May 2012

Now that you have created an SCCP LSAP, you must create a new SCCP route for your system. This step in the Web Portal configuration exists to create a route to a specific destination point code (DPC).

To Create an SCCP Route:


1- Click Create new Sccp Route in the SCCP LSAP configuration window

Toolpack v2.5 Create SCCP Route.png

2- Configure the new SCCP Route:

Toolpack v2.5 Creating SCCP Route.png

3- Verify that the "SccpRoute was successfully created" message appears

Toolpack v2.5 SCCP Route Created.png


List of Parameters