Actions

Difference between revisions of "Toolpack:Creating an SCCP Route A"

Line 28: Line 28:
  
 
* [[Parameter: Name|Name]]
 
* [[Parameter: Name|Name]]
* [[Parameter: Protocol Variant|Protocol Variant]]
+
* [[Parameter: Protocol Type|Protocol Variant]]
 
* [[Parameter: Replicant Mode|Replicant Mode]]
 
* [[Parameter: Replicant Mode|Replicant Mode]]
 
* [[Parameter: SLS Mask|SLS Mask]] (For ANSI and TELCORDIA variants only)
 
* [[Parameter: SLS Mask|SLS Mask]] (For ANSI and TELCORDIA variants only)
 
* [[Parameter: Destination Point Code|Destination Point Code]]
 
* [[Parameter: Destination Point Code|Destination Point Code]]

Revision as of 17:57, 5 August 2010

Now that you have created an SCCP LSAP, you must create a new SCCP route for your system. This step in the Web Portal configuration exists to create a route to a specific destination point code (DPC).

To Create an SCCP Route:


1- Click Create new Sccp Route in the SCCP LSAP configuration window

Toolpack v2.5 Create SCCP Route.png

2- Configure the new SCCP Route:

  • Choose a name for the new route
  • Select a protocol variant
  • Select a replicant mode
  • Select an SLS mask (this is only for ANSI and TELCORDIA protocol variants)
  • Select a destination point code (DPC)
  • Click Create

Toolpack v2.5 Creating SCCP Route.png

3- Verify that the "SccpRoute was successfully created" message appears

Toolpack v2.5 SCCP Route Created.png


List of Parameters