Toolpack:Creating an SCCP Route A: Difference between revisions

Revision as of 10:13, 11 May 2012

Now that you have created an SCCP LSAP, you must create a new SCCP route for your system. This step in the Web Portal configuration exists to create a route to a specific destination point code (DPC).

To Create an SCCP Route:

1- Click Create new Sccp Route in the SCCP LSAP configuration window

2- Configure the new SCCP Route:

Choose a Name for the new route
Select a Protocol Variant
Select a Replication Mode (ANSI96 and TELCORDIA variants)
Select an SLS Mask (ANSI and TELCORDIA protocol variants)
Select a Destination Point Code for this route
Click Create

3- Verify that the "SccpRoute was successfully created" message appears

4- Configure SCCP Route Backup Point Code

Assign Backup Point Codes to use in case this route's DPC is not available.

Note: For each selected point codes, a valid SCCP route must be exist.

List of Parameters

Name
Protocol Variant
Replication Mode
SLS Mask (For ANSI and TELCORDIA variants only)
Destination Point Code

@@ Line 15: / Line 15: @@
 * Select a [[Parameter: Replication Mode|Replication Mode]] (ANSI96 and TELCORDIA variants)
 * Select an [[Parameter: SLS Mask|SLS Mask]] (ANSI and TELCORDIA protocol variants)
-* Select a [[Parameter: Destination Point Code|Destination Point Code]] (DPC) of the node where the route is terminating
+* Select a [[Parameter: Destination Point Code|Destination Point Code]] for this route
 * Click '''Create'''
@@ Line 24: / Line 24: @@
 [[Image:Toolpack_v2.5_SCCP_Route_Created.png]]
+- Configure [[SCCP Route Backup Point Code]]
+* Assign [[Parameter: SCCP Backup Point Code| Backup Point Codes]] to use in case this route's DPC is not available.
+[[Image:SCCP_Route_Backup_PC.png]]
+* '''Note: For each selected point codes, a valid SCCP route must be exist'''.
 ==List of Parameters==