Actions

Difference between revisions of "Toolpack:Creating an SCCP Route A"

Line 15: Line 15:
 
* Select a [[Parameter: Replication Mode|Replication Mode]]
 
* Select a [[Parameter: Replication Mode|Replication Mode]]
 
* Select an [[Parameter: SLS Mask|SLS Mask]] (this is only for ANSI and TELCORDIA protocol variants)
 
* Select an [[Parameter: SLS Mask|SLS Mask]] (this is only for ANSI and TELCORDIA protocol variants)
* Select a [[Parameter: Destination Point Code|Destination Point Code]] (DPC)
+
* Select a [[Parameter: Destination Point Code|Destination Point Code]] (DPC) of the node where the route is terminating
 
* Click '''Create'''
 
* Click '''Create'''
  

Revision as of 19:47, 2 May 2012

Now that you have created an SCCP LSAP, you must create a new SCCP route for your system. This step in the Web Portal configuration exists to create a route to a specific destination point code (DPC).

To Create an SCCP Route:


1- Click Create new Sccp Route in the SCCP LSAP configuration window

Toolpack v2.5 Create SCCP Route.png

2- Configure the new SCCP Route:

Toolpack v2.5 Creating SCCP Route.png

3- Verify that the "SccpRoute was successfully created" message appears

Toolpack v2.5 SCCP Route Created.png


List of Parameters