Toolpack:Configure TMG7800 Ethernet Bonding A: Difference between revisions

Revision as of 15:01, 14 September 2020

Applies to version(s): v3.2

Ethernet Bonding enables two Ethernet ports to be used as bonding pair. This ensures for a reliability of service. If the active port becomes unusable the other port in the bonding pair is used to transport traffic.

To configure Ethernet Bonding:

1. Select Hosts from the navigation panel.

2. Select a Host from the Hosts Configuration list.

3. Click the Status tab.

Select Change Network Devices Role.

4. Select Reset Host Role.

5. A Role Configuration window is displayed.

Set LAN/WAN role to the 2 Ethernet interfaces you want to bond.
Click add bonding
- The bonding pair is displayed below.
Give a name to the bond.
For each LAN/WAN select the associated interface for the bond
Click continue

To verify the Ethernet Bond:

1. Select IP Interfaces from the navigation panel.

2.The bond0 ports are shown.

Click the Status tab.

3. Click the Ethernet Bondings Tab.

Select a Host to view more details.

An Ethernet bonding status window is displayed

@@ Line 43: / Line 43: @@
 *An Ethernet bonding status window is displayed
 [[Image:ConfigureEthernetBonding_8.png]] <br>
-== List of Parameters ==
-*[[Parameter: Name|Name]]
-*[[Parameter: Type|Type]]
-*[[Parameter: Username|Username]]
-*[[Parameter: Password|Password]]
-*[[Parameter: Virtual port|Virtual port]]
-'''Advanced Parameters'''
-*[[Parameter: LCP polling interval|LCP polling interval]]
-*[[Parameter: LCP maximum polling failure|LCP maximum polling failure]]
-*[[Parameter: Overwrite global default gateway|Overwrite global default gateway]]
-*[[Parameter: MTU|MTU]]
-*[[Parameter: MSS clamping|MSS clamping]]