Actions

FreeSBC:Baremetal:Installation A: Difference between revisions

Line 18: Line 18:
# Insert the DVD in the optical drive of your server and boot from the DVD drive.
# Insert the DVD in the optical drive of your server and boot from the DVD drive.
# You should get the to the "Virtual Appliance Installer" menu on your display: <br /> [[File:ISO_install_prompt.jpg|350px]]
# You should get the to the "Virtual Appliance Installer" menu on your display: <br /> [[File:ISO_install_prompt.jpg|350px]]
# Hit 'R' key, then 'ENTER' key.<br /> [[File:ISO_installing.jpg|350px]]
# Hit 'R' key, then 'ENTER' key to start the installation<br /> [[File:ISO_installing.jpg|350px]]
# Wait for the installation process to complete.  When installation is complete, the server will reboot itself.
# Wait for the installation process to complete.  When installation is complete, the server will reboot itself.
#*  Important: Make sure to remove the DVD from the drive while the server is rebooting.  If you get back to "Virtual Appliance Installer", just eject the CD and reboot again.
#*  Important: Make sure to remove the DVD from the drive while the server is rebooting.  If you get back to "Virtual Appliance Installer", just eject the CD and reboot again.

Revision as of 11:31, 13 April 2017

Requirements

Minimal server requirements:

  • Dual core Intel CPU 1.8GHz
  • Optical disk driver
  • 80G hard drive
  • 4G RAM
  • DPDK supported NICs (http://dpdk.org/doc/nics)
  • Console access through serial port or keyboard/monitor ports

Getting the ISO

Please contact our sales team at sales@telcobridges.com to get a copy of the latest TBSC-SW ISO.

Installing using the ISO

The ISO installation process will reformat the server's hardrive and install all the necessary software.

Physical installation steps

  1. Burn the ISO onto a DVD
  2. Insert the DVD in the optical drive of your server and boot from the DVD drive.
  3. You should get the to the "Virtual Appliance Installer" menu on your display:
    ISO install prompt.jpg
  4. Hit 'R' key, then 'ENTER' key to start the installation
    ISO installing.jpg
  5. Wait for the installation process to complete. When installation is complete, the server will reboot itself.
    • Important: Make sure to remove the DVD from the drive while the server is rebooting. If you get back to "Virtual Appliance Installer", just eject the CD and reboot again.

Changing root password

  1. Use the console to login into the server
    1. user: root
    2. password: root
  2. Change the password to something stronger than root:
# passwd
New password: ........
Retype new password: ........
passwd: all authentication tokens updated successfully.

Assigning IP address

  1. Assign a IP address to the Ethernet interface having network connectivity. Example if the NIC's name would be eth0:
 # ip addresss add 192.168.178.30/24 dev eth0
 # ip link set eth0 up

Accessing the TSBC-SW web portal

  1. Open a web browser to the IP of your server, on port 12358. Example if your server address is 192.168.178.30, the URL would be:
 http://192.168.178.30:12358

From here, you can go to Web Portal Initial Configuration Guide to continue the installation, and/or optimize your server to get the maximum out of your server.

Web Portal Initial Configuration

Click on the following link to pursue installation from the web portal: TSBC-SW:WebPortal:Initial Configuration

Optimizations

Click on the following link for baremetal server optimizations: TSBC-SW:Baremetal:Optimizations