Ethernet Bonding: Difference between revisions

Revision as of 14:41, 26 March 2020

Ethernet Bonding enables SBC and Tmedia units to use the two Ethernet ports as a bonding pair. When the active port becomes unusable (cable disconnected, limited connectivity), the other port is used to transport Ethernet traffic.

Note: Ethernet bonding can be configured on an SBC and a 7800-ctrl, but only when running these units in a Bare Metal configuration.

Configuration

To learn how to configure ethernet bonding, refer to:

To learn how to configure ethernet bonding for an FreeSBC or ProSBC, refer to FreeSBC/ProSBC Initial Configuration
To learn how to configure ethernet bonding for a TMG7800, refer to TMG7800 Initial Configuration

Display Status

To learn about how to view the status, refer to:

Ethernet Bonding Status

@@ Line 1: / Line 1: @@
-Ethernet Bonding refers to the capability of Tmedia units to use the two available VoIP Ethernet ports as a bonding pair. When the active port becomes unusable (cable disconnected, limited connectivity), the other port is used to transport Ethernet traffic.
+Ethernet Bonding enables SBC and Tmedia units to use the two Ethernet ports as a bonding pair. When the active port becomes unusable (cable disconnected, limited connectivity), the other port is used to transport Ethernet traffic.
-  Note: Ethernet bonding can be configured on an SBC and a 7800-ctrl, but only running as Baremetal.
+  Note: Ethernet bonding can be configured on an SBC and a 7800-ctrl, but only when running these units in a Bare Metal configuration.
 ==Configuration==
-[[Toolpack:Configuring_Ethernet_Bonding_A|Configuring_Ethernet_Bonding]]
+To learn how to configure ethernet bonding, refer to:
+* To learn how to configure ethernet bonding for an FreeSBC or ProSBC, refer to [[TSBC-SW:WebPortal:Initial_Configuration|FreeSBC/ProSBC Initial Configuration]]
+* To learn how to configure ethernet bonding for a TMG7800, refer to [[TMG7800-CTRL-SW:WebPortal:Initial_Configuration|TMG7800 Initial Configuration]]
 ==Display Status==
-[[Toolpack:Ethernet_Bonding_Status_A|Ethernet Bonding Status]]
+To learn about how to view the status, refer to:
+*[[Toolpack:Ethernet_Bonding_Status_A|Ethernet Bonding Status]]