Actions

Toolpack v2.5:Configuring IP Interfaces

The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:

  • IP Address
  • Netmask
  • Gateway


To configure a VoIP0 or VoIP1 port

1. Select IP Interfaces from the navigation panel:

Toolpack v2.5 Navigation Panel IP Interfaces.png


2. Click Edit from the IP Interfaces Information panel:

Toolpack v2.5 Edit IP Interface.png


3. Configure the IP port:

  • Indicate whether or not to use DHCP on this port
  • Enter an IP address
  • Enter a Netmask
  • Enter a gateway address
  • Click Save

Note: The IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets.

Toolpack v2.5 Editing IP Interface.png


4. The changes are displayed in the IP interfaces information panel:

Toolpack v2.5 IP Interface Edited.png


IMPORTANT! The system will display the following notice, describing steps to apply your new configuration:

Toolpack v2.5 IP Interface Alert.png


5. Activate the configuration

Systems -> Edit -> Activate


6. Reboot the adapter (will drop active calls)

Status -> Adapters -> Click on the adapter Serial Number -> Reboot adapter

It will take about 1.5 minutes to restart the unit.

List of Parameters