Creating the M2UA Configuration

Applies to version(s): v2.5, v2.6.

To create your M2UA system, you must create a new M2UA configuration.

M2UA (Message Transfer Part 2 User Adaptation Layer) is used to interface the MTP2 Layer of a signaling gateway to the MTP3 Layer of a media gateway controller (MGC). M2UA can also be seen as a way to extend an MTP2 link. An M2UA link is always bound to an MTP2 link.

To create an M2UA configuration:

1- Click M2UA in the navigation panel

Toolpack v2.5 Navigation Panel M2UA.png

2- Create the M2UA configuration:

  • Enter a name for the M2UA service
  • Click Create

Toolpack v2.5 Creating M2UA.png

3- Verify that the "M2ua Cfg was successfully created" message appears

Toolpack v2.5 M2UA Created.png

List of Parameters