Creating an SCCP Userpart

Applies to version(s): v2.5, v2.6, v2.7

Now that you have configured an SCCP network:

  • If you are using a TCAP, you must create a new SCCP user part, so that you can bind the SCCP and TCAP later on.

The user part is the container for the multiple SCCP interfaces. One user part is required for each protocol variant. Multiple SCCP user parts can be instantiated within a single SCCP protocol layer. This allows a user application to interface with multiple SS7 SCCP protocol variants at the same time. Only one SCCP user part is required for a specific variant as it can be assigned to multiple SCCP networks.

A user part can easily be seen as a protocol variant that a host application wants to use on the SS7 network.

To create an SCCP user part:

1- Click Create New SCCP User Part to access the SCCP configuration window

Toolpack v2.5 Create SCCP Userpart.png

2- Configure the new SCCP user part

Toolpack v2.5 Creating SCCP Userpart.png

3- Verify that the "SCCP Userpart was successfully created" message appears

Toolpack v2.5 SCCP Userpart Created.png

4- Next Step: Create an SCCP LSAP

List of Parameters


Previous Next
Create an SCCP Network Create an SCCP LSAP