Actions

Creating an M3UA Configuration (SGP)

Applies to version(s): v2.5, v2.6, v2.7

To set up your M3UA system on a signaling gateway process (SGP), you must first create a new M3UA configuration. In this configuration the SS7 MTP2 layer is replaced entirely by the SIGTRAN M3UA layer, and the MTP3 layer is extended over the IP network.

To create an M3UA configuration on an SGP:


1- Click M3UA in the navigation panel

Toolpack v2.5 Navigation Panel M3UA.png

2- Configure the M3UA service for SGP:

  • Enter a name for the configuration
  • Select Signaling Gateway Process (SGP) as the node type
  • Click Create

Toolpack v2.5 Creating SGP M3UA Configuration.png

3- Verify that the "M3ua Cfg was successfully created" message appears

Toolpack v2.5 M3UA IPSP Configuration Created.png


List of Parameters