Actions

Creating an ISUP Interface

Applies to version(s): v2.5, v2.6., v2.7

Now that you have created an ISUP user part to contain them, you must create new ISUP interfaces.

The ISUP interface creates a binding within the ISUP layer of a particular variant, a specific network, and an OPC/DPC pair to which circuits can be assigned.

The ISUP interface contains the circuit identifier codes (CICs) within the ISUP user part. One interface is created for each similar grouping of CICs within one user part protocol variant.

To create an ISUP interface:


1- Click Create New Isup Interface in the ISUP stack configuration window

Toolpack v2.5 Create ISUP Interface.png

2- Configure the new ISUP interface:

  • Enter a name for the interface
  • Select an ISUP user part
  • Select an ISUP network
  • Select a trunk type
  • Select an originating point code (OPC)
  • Select a destination point code (DPC)
  • Click Create

Toolpack v2.5 Creating ISUP Interface.png

3- Verify that the "IsupInterface was successfully created" message appears

Toolpack v2.5 ISUP Interface Created.png


List of Parameters