Actions

Toolpack:Create an SCCP LSAP

Creating a Lower Service Access Point (LSAP) tells the SCCP protocol layer about a collection of SS7 nodes that are accessible through MTP3.


Description of parameters

General explanation of the configuration parameters:

  • The Handle SCCP network parameter specifies the handle of the SCCP network
  • The Unique identifier SCCP LSAP parameter specifies the unique ID of the SCCP LSAP for a SS7 system
  • The Unique identifier MTP3 userpart parameter specifies the unique ID of the MTP3 userpart to which this LSAP is connected
  • The Maximum message length parameter specifies the maximum length of the message delivered to SCCP from this LSAP


Further reading

Configuring an SCCP LSAP (Toolpack v2.5)