Actions

Toolpack: Configuring RADIUS

Applies to version(s): v2.3, v2.4, v2.5.

This page describes how to configure a RADIUS server for accounting in Toolpack v2.5 or earlier.

1- Select Gateway -> Configurations from the navigation panel.

RADIUS v2 5 gw menu configurations.png


2- Verify that the box Use CDR behavior is checked.

RADIUS v2 5 gw cdr check.png


3- Configure the CDR behavior in the CDR Options section:

  • Select Radius CDR in the CDR Mode combo box.
  • In the Radius server parameters section, set the Radius server address and port and Server secret fields.
  • Click Save to save your changes.

RADIUS v2 5 gw cdr configuration.png


4- Verify that the Gateway configuration was successfully updated. message appears.

RADIUS v2 5 gw cfg success.png