Adding M2PA Links

Applies to version(s): v2.5, v2.6., v2.7

Now that you have created an M2PA service access point (SAP), you must create a new M2PA link. This can be done from the M2PA SAP configuration window. To create an M2PA link:

1- Click Create new M2pa link in the M2PA SAP configuration window:

Toolpack v2.5 Create M2PA Link.png

2- Configure the new link:

  • Enter a name for the link
  • Select a protocol type:
  • Set other features, as needed:
    • Number of SCTP Streams
    • IP Header TOS
    • Destination port (same value as the one configured on the destination side)
  • Click Create

Toolpack v2.5 Creating M2PA Link.png

3- Enter a destination address in the appropriate box in the information panel:

  • Click the "<<" button to add the destination address to the address list

Toolpack v2.5 M2PA Link Address.png

4- Verify that the address has been added to the list, and that the "(your address) was successfully added" message appears (ex.: here the address is

Toolpack v2.5 M2PA Link Address 2.png

List of Parameters