Creating the M2UA Configuration
| This article applies to: | Product | Version |
| Tmedia | 2.9, 2.10, 3.0, 3.2 |
To create your M2UA system, you must create a new M2UA configuration.
M2UA (Message Transfer Part 2 User Adaptation Layer) is used to interface the MTP2 Layer of a signaling gateway to the MTP3 Layer of a media gateway controller (MGC). M2UA can also be seen as a way to extend an MTP2 link. An M2UA link is always bound to an MTP2 link.
To create an M2UA configuration:
1- Click M2UA in the navigation panel
2- Create the M2UA configuration:
- Enter a name for the M2UA service
- Select a Node Type (SG, ASP, M2UA-MTP2 Relay)
- Click Create
3- Verify that the "M2ua Cfg was successfully created" message appears
Path
/configurations/@[configuration_name]/hardware_units/@[hardware_name]/m2ua_stacks/@[m2ua_stack]
Parameters (text)
/configurations/@[configuration_name]/hardware_units/@[hardware_name]/m2ua_stacks/@[m2ua_stack] enabled = true name = "@[m2ua_stack]" node_type = "Signaling Gateway (SG)" /configurations/@[configuration_name]/hardware_units/@[hardware_name]/m2ua_stacks/@[m2ua_stack]/advanced_parameters one_identifier_per_primitive = false /configurations/@[configuration_name]/hardware_units/@[hardware_name]/m2ua_stacks/@[m2ua_stack]/timers ack_timer = "1 second" as_pending_timer = "1 second" heartbeat_timer = "" nb_aspm_retry = 5 sctp_poll_timer = "1 second" ss7_cong_poll_timer = "1 second"
Parameters (json)
{
"advanced_parameters" : {
"one_identifier_per_primitive" : false
},
"enabled" : true,
"name" : "@[m2ua_stack]",
"node_type" : "Signaling Gateway (SG)",
"timers" : {
"ack_timer" : "1 second",
"as_pending_timer" : "1 second",
"heartbeat_timer" : "",
"nb_aspm_retry" : 5,
"sctp_poll_timer" : "1 second",
"ss7_cong_poll_timer" : "1 second"
}